In the Customize dialog - Screen Layout tab, the Cine Viewer can be set to a default scope of either series or study. When set to series, one Cine Viewer appears to control all displayed series. When set to study, separate Cine Viewer controls appear for each displayed series. In the latter case, you can temporarily change the display to an individual series for closer inspection, then return to the multi-Cine Viewer layout.
To cine an individual series when in multi-series cine mode
Change the scope to series.
Click the series to display individually.
A small, scaled-down Cine Viewer toolbar appears, indicating the number of frames in the series. The series is surrounded by a border to indicate that it is active.
Use the scaled-down Cine Viewer toolbar:
To navigate through the frames, use the slider bar or click Previous or Next.
To stop the cine, click Stop.
To restart the cine, click Play.
When done, click the series again to deselect it.
The border disappears. The series stops, but synchs up with other series at the start of the next run.
If done with cine on individual series, change the scope back to study.
To switch between individual and multi-series cine mode
On the Cine toolbar, click Cine One Series
if
the button is not already set to Cine All Series. 
If you do not see this control, you can add it as the Continuous control from the Customize dialog.