IMPAX 6.5.1 Application Server Knowledge Base > Configuring spoke and hub communications > Configuring communication between spoke HL7 Out and hub HL7 In on Connectivity Manager
To enable the hub Connectivity Manager to receive orders and reports from the spoke Connectivity Manager, configure HL7 communication from the spoke Connectivity Manager to the hub Connectivity Manager.
To set the name of the spoke Connectivity Manager
In the Imaging Service Request Object section, locate the entry where the Destination Expression is mcf('requesting_service') and in the Source Expression, type the name of the spoke Connectivity Manager you specified previously.
Click Save.
Click OK.
Click Done.
On the Real World Devices screen, for the HUB_FROM_SPOKE_AETitle device that you specified in step 4 of the general HL7 setting configuration, select the HL7 In checkbox.
Click Re/Start to apply the changes.
Topic number: 54644 Applies to: IMPAX 6.5.1 Application Server Knowledge Base |